I just noticed that my two pfSense boxen aren't syncing anymore.
In the
logs, I see:
An error code was received while attempting XMLRPC sync with
username
admin https://192.168.8.1:443 - Code 2: Invalid return payload:
enable
debugging to examine incoming payload
How can I enable XMLRPC debugging and run it from the CLI?
I haven't been able to figure out this problem. I've tried to do a
backup of
my primary router's config, and then restore it on the secondary
box, but
that didn't resolve the issue.
You shouldn't do that, that will configure the secondary to sync to
itself, which could cause problems (though we have checks that should
prevent that from breaking anything).
I didn't copy over all the configs; just the DHCP, DNS and filter rules.
Post your configurations and maybe something will be apparent. Email
them to me offlist if you prefer.
I'll send them to you, thanks for offering your eyes.
One thing I did notice in the logs is from the secondary router, it
complains:
php: /xmlrpc.php: Disallowing CARP sync loop.
The secondary box's CARP settings:
Synchronize Enabled checked
Synchronize Interface CARPSYNC
pfSync sync peer IP 192.168.8.1
Synchronize to IP 192.168.8.1
Remote System Password (set)
Everything else is unchecked
The primary box has 192.168.8.2 as the "sync peer" and "Synchronize
to" IP, everything checked.
Thanks all -
Ian
---------------------------------------------------------------------
To unsubscribe, e-mail: support-unsubscr...@pfsense.com
For additional commands, e-mail: support-h...@pfsense.com
Commercial support available - https://portal.pfsense.org
