Hello,
I am working on setting up couple of high end firewall based on
Advantech Hardware.
http://www.osnet.eu/en/content/opensource-firewall-fwa-3140
Everything goes well if we use the embedded version of the OS = infos
are displayed correctly on the console during the boot, and after when
the pfSense menu is displayed, User can input data at any stage.
If I install a full version, then I only have infos up to a certain
point (early boot of the OS) after that, nothing is displayed on the
console port… but everything is mapped to the VGA port which is
located inside the firewall on these device… I have to completely open
the box to access the VGA port. Furthermore, It is very annoying for
customers not to have a full console access as this is the best
emergency solution to use.
Would you please let me know which file(s) I have to copy from the
embedded version to the full version in order to have the same console
behavior on full install?
Thank you very much.
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Gregober ---> PGP ID --> 0x1BA3C2FD
bsd @at@ todoo.biz
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
P "Please consider your environmental responsibility before printing
this e-mail"
---------------------------------------------------------------------
To unsubscribe, e-mail: support-unsubscr...@pfsense.com
For additional commands, e-mail: support-h...@pfsense.com
Commercial support available - https://portal.pfsense.org