Hi all, i'm using pfsense 1.2.2 on a borad with 4 Fisical Interfaces
configured in this way:
rl1 -> WAN
rl0 -> LAN
rl2 -> is an 802.1q trunk "splitted" in three VLAN
Now i needed to use the fourth interface in this way:
I need this interface to have an IP belonging to the network ip of one
of the DMZ of my Firewall ( PIX 525 ).
So i set-up a layer-2 connection of the fisical interface rl3 in order
to have it on the same subnet of that DMZ.
I set up the new OPT-Interface with pfsense-Gui and give it an IP
address of the same network; i setup FW rules on this new interface
with a permit anyTOany ( as a test ).
First question: when i see the routing tables on pfsense it shows me the
subnet associated to rl3, but the ip address is associated to lo0 Netif.
Could some one explain why ??
Second question: when i test a ping to the PIX-IP on that DMZ i can't
reach it ( i'm sure L2-connectivity is OK ); some one could help ??
Thanks a lot in advance,
--Andrea
--
Ing. Andrea Russos
Comune di Modena - Settore Sistemi Informativi
CED - Ufficio Sistemi&Reti
Tel: +390592033553
e-mail: arus...@comune.modena.it
---------------------------------------------------------------------
To unsubscribe, e-mail: support-unsubscr...@pfsense.com
For additional commands, e-mail: support-h...@pfsense.com
Commercial support available - https://portal.pfsense.org