On Thu, Mar 18, 2010 at 3:04 PM, mayak-cq <ma...@australsat.com> wrote: > hi all, > > i've got a serious policy routing problem that i cannot seem to > overcome. > > the pfsense box has three interfaces: two are wan ports and one is lan > -- both wan ports share the same physical media and use the same > gateway. they each have a different ip address. > > i need to route outbound mail traffic out of one specific interface and > voip out the other (among other requirements). > > since the gateway's are the same, and because i cannot specify the > interface but only the next router, pfsense seems to choose the > first/lowest interface to send mail. > > is there a way around this? > > thanks > > m > I have not tested this but an advanced outbound NAT setup where you specify either the source or destination port and NAT address could work.
Curtis LaMasters http://www.curtis-lamasters.com http://www.builtnetworks.com --------------------------------------------------------------------- To unsubscribe, e-mail: support-unsubscr...@pfsense.com For additional commands, e-mail: support-h...@pfsense.com Commercial support available - https://portal.pfsense.org