Has anyone had a setup with 2 WAN connections(stupid question I guess
:)? WAN is PPTP connected with IP 81.147.x.x and OPT1 is regular
ethernet with 79.160.x.x. What I am experiencing is that on
Status--->Interfaces, gateway is set to the same for both WAN and OPT1.
This is pfsense 1.2.3.
I'm trying to do a loadbalanced setup between these two wan connections,
and seeing that the gateway is the preferred ip to check against, though
I guess it should have shown up right in Status-> Interfaces in the
first place?
wan = vr0
lan= re0
opt1 = vlan2 on vr0
Knut Petter
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
