On Sat, Jan 22, 2011 at 2:05 PM, Ermal Luçi <ermal.l...@gmail.com> wrote: > On Sat, Jan 22, 2011 at 4:07 PM, Alberto Mijares <amijar...@gmail.com> wrote: >> Greetings, >> >> I need a router with a V.35 interface for my frame relay link. I found >> that ctau(4) driver in FreeBSD 8.x may handle this PCI card[1], so my >> question is: does pfSense 2.x support this card and may be used as >> WAN interface? I think so, since pfSense 2.x is based on FreeBSD 8.1 >> and keeps all driver, isn't it? > > You can try grab the module from a standard freebsd iso and load it in > pfSense. > You will have to grab even sconfig utitlity for this and is not > supported from the GUI. > > Than you can go and do some test on the PPP page for it.
What you say is I must configure the channel parameters from the CLI (with sconfig) and then configure the WAN interface (cp0 in this case) as a PPP link from the GUI. Is that correct? In this case I must manually edit rc.conf for the channel settings at startup, rigth? I need to know if it is going to work because we don't have much money for spending in tests. Has anyone done this before? Should I take another box with FreeBSD 8.X or Linux as a router? A low cost router with V.35 interface perhaps? Any suggestion? Thanks for your help. Alberto Mijares --------------------------------------------------------------------- To unsubscribe, e-mail: support-unsubscr...@pfsense.com For additional commands, e-mail: support-h...@pfsense.com Commercial support available - https://portal.pfsense.org