Hallo,
ich hab ein Problem mit meinem X-Server.
nach kurzer Zeit, meist nachdem ich etwas mit der Maus
"gewackelt" habe bleibt X stehen und es hilft nur noch
ein Reset !!
Meine Konfiguration:
5x86-S Cyrix 100 MHz,
16 MB Extended Memory
128 K Cache Memory
Advance Logic ALG - 2302 Grafikkarte mit 1024 KDRAM
Swap: 30 MB
Microsoft Bus Maus
fvwm95 - SVGA Server mit 256 Farben.
Hab ich vielleicht zu wenig Hauptspeicher ?
das kleine Fenster zeigt 14 M an
Swap ist bei 5.2 M
Attached hab ich die Meldungen von startx sowie meine
XF86Config.
Vielen Dank
Uli
XFree86 Version 3.3.3 / X Window System
(protocol Version 11, revision 0, vendor release 6300)
Release Date: November 18 1998
If the server is older than 6-12 months, or if your card is newer
than the above date, look for a newer version before reporting
problems. (see http://www.XFree86.Org/FAQ)
Operating System: Linux 2.1.129 i686 [ELF]
Configured drivers:
SVGA: server for SVGA graphics adaptors (Patchlevel 0):
NV1, STG2000, RIVA128, RIVATNT, ET4000, ET4000W32, ET4000W32i,
ET4000W32i_rev_b, ET4000W32i_rev_c, ET4000W32p, ET4000W32p_rev_a,
ET4000W32p_rev_b, ET4000W32p_rev_c, ET4000W32p_rev_d, ET6000, ET6100,
et3000, pvga1, wd90c00, wd90c10, wd90c30, wd90c24, wd90c31, wd90c33,
gvga, ati, sis86c201, sis86c202, sis86c205, sis86c215, sis86c225,
sis5597, sis5598, sis6326, tvga8200lx, tvga8800cs, tvga8900b,
tvga8900c, tvga8900cl, tvga8900d, tvga9000, tvga9000i, tvga9100b,
tvga9200cxr, tgui9400cxi, tgui9420, tgui9420dgi, tgui9430dgi,
tgui9440agi, cyber9320, tgui9660, tgui9680, tgui9682, tgui9685,
cyber9382, cyber9385, cyber9388, cyber9397, cyber9520, 3dimage975,
3dimage985, clgd5420, clgd5422, clgd5424, clgd5426, clgd5428,
clgd5429, clgd5430, clgd5434, clgd5436, clgd5446, clgd5480, clgd5462,
clgd5464, clgd5465, clgd6205, clgd6215, clgd6225, clgd6235, clgd7541,
clgd7542, clgd7543, clgd7548, clgd7555, clgd7556, ncr77c22, ncr77c22e,
cpq_avga, mga2064w, mga1064sg, mga2164w, mga2164w AGP, mgag200,
mgag100, oti067, oti077, oti087, oti037c, al2101, ali2228, ali2301,
ali2302, ali2308, ali2401, cl6410, cl6412, cl6420, cl6440, video7,
ark1000vl, ark1000pv, ark2000pv, ark2000mt, mx, realtek, s3_virge,
AP6422, AT24, AT3D, s3_svga, NM2070, NM2090, NM2093, NM2097, NM2160,
NM2200, ct65520, ct65525, ct65530, ct65535, ct65540, ct65545, ct65546,
ct65548, ct65550, ct65554, ct65555, ct68554, ct69000, ct64200,
ct64300, mediagx, V1000, V2x00, p9100, spc8110, generic
(using VT number 7)
XF86Config: /etc/XF86Config
(**) stands for supplied, (--) stands for probed/default values
(**) XKB: rules: "xfree86"
(**) XKB: model: "pc104"
(**) XKB: layout: "us"
(**) XKB: keymap: "xfree86(de)" (overrides other XKB settings)
(**) Mouse: type: Microsoft, device: /dev/mouse, baudrate: 1200
(**) Mouse: samplerate: 60, buttons: 3
(**) Mouse: 3 button emulation (timeout: 50ms)
(**) SVGA: Graphics device ID: "Avance"
(**) SVGA: Monitor ID: "Monitor"
(--) SVGA: Mode "1152x864" needs vert refresh rate of 44.46 Hz. Deleted.
(--) SVGA: Mode "1600x1000" needs hsync freq of 28.80 kHz. Deleted.
(--) SVGA: Mode "1280x960" needs vert refresh rate of 35.89 Hz. Deleted.
(--) SVGA: Mode "1600x1200" needs hsync freq of 28.80 kHz. Deleted.
(--) SVGA: Mode "1280x1024" needs vert refresh rate of 33.64 Hz. Deleted.
(--) SVGA: Mode "1024x768" needs vert refresh rate of 120.01 Hz. Deleted.
(**) FontPath set to
"/usr/X11R6/lib/X11/fonts/misc,/usr/X11R6/lib/X11/fonts/75dpi:unscaled,/usr/X11R6/lib/X11/fonts/100dpi:unscaled,/usr/X11R6/lib/X11/fonts/Type1,/usr/X11R6/lib/X11/fonts/Speedo,/usr/X11R6/lib/X11/fonts/75dpi,/usr/X11R6/lib/X11/fonts/100dpi,/usr/X11R6/lib/X11/fonts/local/,/usr/X11R6/lib/X11/fonts/misc/,/usr/X11R6/lib/X11/fonts/75dpi/:unscaled,/usr/X11R6/lib/X11/fonts/100dpi/:unscaled,/usr/X11R6/lib/X11/fonts/Type1/,/usr/X11R6/lib/X11/fonts/Speedo/,/usr/X11R6/lib/X11/fonts/75dpi/,/usr/X11R6/lib/X11/fonts/100dpi/"
(--) SVGA: PCI: Unknown vendor (0x4005) Unknown chipset (0x2302) rev 0, Memory @
0xfc000000
(--) SVGA: chipset: al2101
(**) SVGA: videoram: 1024k
(--) SVGA: clocks: 24.78 28.32 22.13 35.40 37.17 31.86 38.94 39.83
(**) SVGA: Option flag "16clocks" is not defined for this driver
(**) SVGA: Using 8 bpp, Depth 8, Color weight: 666
(--) SVGA: Maximum allowed dot-clock: 90.000 MHz
(**) SVGA: Mode "800x600": mode clock = 40.000, clock used = 39.830
(**) SVGA: Virtual resolution set to 800x600
(--) SVGA: SpeedUp code selection modified because virtualX != 1024
(**) Adding extended device "SWITCH" (type: Switch)
xrdb: "*XmText.Translations" on line 13 overrides entry on line 10
X connection to :0.0 broken (explicit kill or server shutdown).
X connection to :0.0 broken (explicit kill or server shutdown).
X connection to :0.0 broken (explicit kill or server shutdown).
xterm: fatal IO error 32 (Broken pipe) or KillClient on X server ":0.0"
X connection to :0.0 broken (explicit kill or server shutdown).
X connection to :0.0 broken (explicit kill or server shutdown).
xterm: fatal IO error 32 (Broken pipe) or KillClient on X server ":0.0"
xinit: connection to X server lost.
waiting for X server to shut down ..
XF86CONF
