What about using a male & female threaded connecters with O rings? Just flatten a small area of the drum put an O ring on the male connecter, slip the connecter through a hole in the drum that is just barely big enough for the connecter to fit in, another O ring, then screw on the female connecter and tighten.
Greg H. ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <biofuel@yahoogroups.com> Sent: Saturday, January 18, 2003 09:20 Subject: [biofuel] Re: Drum Modification > I'd braze onto the drum. In order to braze, you use flux and a > bronze/brass filler wire. Note that it does not involve melting the > steel of the drum. You can't do it with a MIG welder, but can use a > carbon arc brazing attachment on a ordinary stick welder. Although to > be brutally honest, I wouldn't waste your time with these toys and > beg/steel/borry a oxy/propane setup and braze with that because you'll > get better results. > > Hugh > > > Biofuel at Journey to Forever: > http://journeytoforever.org/biofuel.html > > Biofuels list archives: > http://archive.nnytech.net/ > > Please do NOT send Unsubscribe messages to the list address. > To unsubscribe, send an email to: > [EMAIL PROTECTED] > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Biofuels list archives: http://archive.nnytech.net/ Please do NOT send Unsubscribe messages to the list address. To unsubscribe, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/