Is ":-) I'd suggest you check on whether the process is watertight before you start bothering about the reactor. (It ain't!) " in reference to base catalyzed reactions or something else?
I'm sorry Andy, I don't see how it could refer to anything other than the Biox reaction, it's not ambiguous. If you'd checked the links I gave you you'd have found not only further confirmation of that but a lot more information, including some you just said you've been looking for. So why don't you just do that? Here they are again:
> See: > > http://infoarchive.net/sgroup/biofuel/35434/ > > http://infoarchive.net/sgroup/BIOFUEL/35449/ > > Check the links in those posts.
It's a blind alley anyway, unless you really are doing advanced stuff (more advanced than Biox). Have you made any biodiesel yet, single-stage base test batches for instance?
Keith
Andy On Sat, 15 Jan 2005 02:07:51 +0900, Keith Addison <[EMAIL PROTECTED]> wrote: > Hello Andy > > >I am helping a friend setup a reactor and he has 4 55 gallon drums of > >IPA. He has little time so it is slow going, but I will let you know > >how it goes. Since the it has the higher boiling point we will run at > >a higher temperatures. > > > >I am interested in trying the BIOX reaction as well but want to make > >sure that the reactor is air tight first. > > :-) I'd suggest you check on whether the process is watertight before > you start bothering about the reactor. (It ain't!) Rather thoroughly > discussed here previously, a few times. I think calling it "the BIOX > reaction" might be somethinbg of a misnomer, for one thing. > > See: > > http://infoarchive.net/sgroup/biofuel/35434/ > > http://infoarchive.net/sgroup/BIOFUEL/35449/ > > Check the links in those posts. > > Best wishes > > Keith > > > >Andy > > > > > >On Fri, 14 Jan 2005 09:12:26 -0300, Andres Yver <[EMAIL PROTECTED]> wrote: > > > On Thursday, January 13, 2005, at 05:50 AM, Jan Warnqvist wrote: > > > > > > > Hello there ! > > > > Is there anyone who has experience in isopropyl alcohol or its esters > > > > as fuel components ? > > > > Jan Warnqvist > > > > > > > > > Here's a pdf out of Iowa State University: > > > > > > www.me.iastate.edu/biodiesel/Technical%20Papers/Wang%20Intro.pdf > > > > > > The production of isopropyl esters and their effects on a diesel engine > > > > > > "The scope of this research was to improve the cold weather properties > > > of neat biodiesel > > > by investigating the manufacture of isopropyl esters from soybean oil > > > and yellow grease. > > > Isopropyl esters have a lower crystallization temperature compared to > > > methyl esters from the same source material." > > > > > > www.me.iastate.edu/biodiesel/Technical%20Papers/ > > > Wang%20Equip%20Analysis%20Results.pdf > > > > > > Optimizing the Transesterification Process for Isopropyl Esters > > > > > > "Producing isopropyl esters requires the use of isopropyl alcohol as > > > opposed to methyl > > > esters, which utilize methanol, or ethyl esters, which use ethanol. > > > Commonly, most biodiesel > > > consists of methyl esters and methanol is used since it is cheap and > > > widely available. > > > Methanol is priced between $.04-.24/lb [14] and is the fourth largest > > > organic chemical in the U.S. in terms of volume. Isopropanol, on the > > > other hand, is priced between $.20 - .34/lb [14], which makes it more > > > expensive to make isopropyl esters. However, the yield for isopropyl > > > esters is about 10% more than methyl esters because of the heavier > > > molecular weight. So, this partially compensates for the increased > > > cost." > > > > > > hth, > > > andres yver
_______________________________________________ Biofuel mailing list [EMAIL PROTECTED] http://wwia.org/mailman/listinfo.cgi/biofuel Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Biofuel archives at Infoarchive.net (searchable): http://infoarchive.net/sgroup/biofuel/