Could you please send it to me too. Thanks. Chris -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of JJJN Sent: Thursday, May 18, 2006 5:00 PM To: Biofuel@sustainablelists.org Subject: Re: [Biofuel] BETTER MIXING BETTER BIODIESEL LESS ENERGY
Hello Citando, I sent you a schematic and after reading this you should understand the benefits. This is all based on experience. I just made a 100 Liter batch and the color was so light it looks like virgin oil, It separated in COLD water on the first mix in under a minute. was clear as crystal on the 4th wash. Keep in mind this is not changing the way any JtF procedures are done, It is just an enhancement. use it where you are but don't start on the acid base start at the beggining. See below [EMAIL PROTECTED] wrote: >Hello Jim I, > would like to know more about that. >tank you > >Citando JJJN <[EMAIL PROTECTED]>: > > Wouldst it be cool if we had a way of doing these: > IMPROVING THE SAFE HANDLING OF CHEMICALS? > > A PVC venturi fitting installed on the discharge side of the pump allows yous to suck in your chemicals using a small hose. The pumps horspower when used to push the oil through the fitting causes a vacume at the port down stream of the Orfice or hole that the oil travels through. If you hook a small plastic hose to this you can pull in chemical without pouring it in. This is safe. > Injecting all our chemicals into our oil without pouring them in? > > see above > During the process of injection, getting a better than 90% total mix? > > This is one of the great side benefits of what happens when the oil is forced through the orfice - it creates a vacume on the other side when a fluid is sucked in to this area down stream of the orfice a super turbulent hyper mixing action takes place and mixes whatever with the oil - and it will stay that way much longer than through any other type of mixing - This is the principal that the University of Cambridge uses for their processor. > Keep the top 1" (where any unmixed Methoxil sits in your processor) > mixed with the rest? > > Yes no matter how you do it some separation of methoxil and oil is going to happen and it goes to the top. But with the venturi you simply place the suction tube to a port that goes down into the processor and pulls this "top layer" back into the mix with oil from the bottom of the reactor. When the hour is up you end up with Hyper mixed fluid. > Reclaim the methanol from the glycerin of the last batch right back into > the fresh oil of a new batch? > > After you have made a Batch of bio you have a batch of FA - GL (fatty acids Glyceryn) put this in a container with one outlet. Place the suction tube on the outlet. Turn on your pump. (bench mark where the oil is so you can see how much methanol you have pulled in) now gently heat the container of FA-GL Under vacume it will boil out the methanol. as this hot gas is mixed with the cool oil (at atmospheric pressure) it instantly turns to liquid and mixes at the same time. (for acid base only) > Reclaim the methanol from the Biodiesel before washing (allowing for a > washing experience you may not have ever experienced)? > > Before you wash your bio turn your pump onn with the venturi on hook it to a chilled reclaimer vessel and hook the syuction port to one side and another line to your processor and be sure you have a closed system. the methanol will drop out in the reclaimer and will be very pure. Once you have it out the bio will wash much better than it did with the methanol in it. One thing NEVER EVER NEVER hook the suction to a water port for washing - this is a gauranteed emulsion with the best bio made. because the venturi mixes so well it will take a long time to settle out. (but it will eventualy) > > Well I do have a way and I would like to share it, Joe Street and I have > both been developing this technique along parallel lines of thought and > it works so well, and it IMPROVES SAFETY. > > Better than that it cost's about 20 bucks to add to your processor. > > These can be purchased from the internet very reasonably. > > Reply if you want to know if I'm tooting bull or like Bob Allen says, > "can give the proof of the pudding" - this car does not run on water. ;^) > > Jim > > > > _______________________________________________ > Biofuel mailing list > Biofuel@sustainablelists.org > http://sustainablelists.org/mailman/listinfo/biofuel_sustainablelists.or g > > Biofuel at Journey to Forever: > http://journeytoforever.org/biofuel.html > > Search the combined Biofuel and Biofuels-biz list archives (50,000 messages): > http://www.mail-archive.com/biofuel@sustainablelists.org/ > > > > > >__________________________________________________________ >Email gratuito com 2 000 MB >Espaço para guardar 1 milhão de mensagens >http://www.portugalmail.pt/2000mb > >_______________________________________________ >Biofuel mailing list >Biofuel@sustainablelists.org >http://sustainablelists.org/mailman/listinfo/biofuel_sustainablelists.o rg > >Biofuel at Journey to Forever: >http://journeytoforever.org/biofuel.html > >Search the combined Biofuel and Biofuels-biz list archives (50,000 messages): >http://www.mail-archive.com/biofuel@sustainablelists.org/ > > > > _______________________________________________ Biofuel mailing list Biofuel@sustainablelists.org http://sustainablelists.org/mailman/listinfo/biofuel_sustainablelists.or g Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Search the combined Biofuel and Biofuels-biz list archives (50,000 messages): http://www.mail-archive.com/biofuel@sustainablelists.org/ _______________________________________________ Biofuel mailing list Biofuel@sustainablelists.org http://sustainablelists.org/mailman/listinfo/biofuel_sustainablelists.org Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Search the combined Biofuel and Biofuels-biz list archives (50,000 messages): http://www.mail-archive.com/biofuel@sustainablelists.org/