Hello! Am 03.03.05 schrieb Beat Rubischon:
> I'm trying to configure a ISDN backup link on a Cisco. First, thanks a lot for your ideas. I have now debugged a lot and my results are the following: - It's not a problem in the wiring or termination. - Dial-Out is possible when Layer 2 is in state "MULTIPLE_FRAME_ESTABLISHED" (aka an running call) or "NOT Activated" (not initialized yet) - Dial-Out is not possible when Layer 2 is in state "TEI_ASSIGNED", debugging shows that the communication simple times out. I assume now a bug in the IOS - 12.3(8)YA [1] is an early deployment release. I hope to get my service contract soon to access other images. [1] http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/prod_bulletin0900aecd80157bb5.html A disconnect of the S-Bus resets the Layer 2 and with the setting "isdn tei-negotiation first-call" no new TEI is allocated. So I will try to switch off Layer 1 - each time Swisscom shuts down Layer 1, my BRI would be resetted :-) May be someone has another idea. I have put the config and a logfile on [2]. [2] http://www.rubis.ch/isdn/ Beat -- Beat Rubischon \|/ See http://www.rubis.ch/~beat/ for <[EMAIL PROTECTED]> ( 0^0 ) snail- & e-mail, phone, fax & PGP ---------------oOO--(_)--OOo---------------------------------- # wigwam.lugs.ch, Linux 2.4.29-rc2, up 49 days, 9:14, load: 0.14 _______________________________________________ swinog mailing list swinog@lists.swinog.ch http://lists.swinog.ch/cgi-bin/mailman/listinfo/swinog