Dear Btohers, Troy's solution worked, even though the module was generated from an OSIS file.
In the end, I changed the ThML to OSIS to be proper (and it still worked). Thank you very much for your help and interest. In Christ, Kamal > Is the file osis or thml? Sent from my phone On Oct 18, 2010, at 3:22 PM, "Troy A. Griffitts" <scr...@crosswire.org> wrote: > Dear Kamal, > > Try adding this line to your .conf file: > > GlobalOptionFilter=ThMLLemma > > > > On 10/18/2010 03:34 PM, Kamal Abou Mikhael wrote: >> Hi Troy, >> >> Here's the .conf >> >> [AraSVDStrongs] >> DataPath=./modules/texts/rawtext/arasvdstrongs/ >> ModDrv=RawText >> SourceType=ThML >> GlobalOptionFilter=ThMLFootnotes >> GlobalOptionFilter=ThMLScripref >> GlobalOptionFilter=ThMLHeadings >> Encoding=UTF-8 >> Direction=RtoL >> Lang=ar >> SwordVersionDate=2007-06-09 >> Version=1.070609k >> History_1.0=Initial. >> Description=Arabic Smith & Van Dyke >> About=AraSVD with Strongs Numbers >> LCSH=Bible. Arabic. >> DistributionLicense=None >> >>> What does your .conf file look like? >>> >>> On 10/17/2010 10:28 PM, Kamal Abou Mikhael wrote: >>> >>>>> Hi Everyone, >>>>> >>>>> I'm trying to create a Bible with Strong's numbers. >>>>> I converted the document to a module and tested it using BibleTime. >>>>> >>>>> In order to get the Strong's definitions to show in the mag, I had to >>>>> use lemma="G80" instead of the lemma="strong:G80" recommended by the >>>>> wiki article. >>>>> >>>>> As far as the morphology, I was able to get the entries to show in the >>>>> mag by copying the Robinson module to my .sword and renaming it "robinson". >>>>> >>>>> However, multiple Strong's numbers and multiple morphologies do not >>>>> display properly in the mag, they are shown literally as was the case >>>>> for single values prior to applying the above fixes after experimenting. >>>>>
_______________________________________________ sword-devel mailing list: sword-devel@crosswire.org http://www.crosswire.org/mailman/listinfo/sword-devel Instructions to unsubscribe/change your settings at above page