I am working in Meditech Magic with Workstation 3.x. I have a script that closes my LSS databases. In the screen where I am looking for the transfer of the data from the clinics (which use PRV) to complete, there is a pop up that says "Again?". This causes the screen I want to look at to not be the current screen. I have used the command Key "@_LASTSCREEN" to check for the word COMPLETE in the status field.
This works absolutely perfectly when I start the script manually. However the script has to run between midnight and 7am and I'm tired of getting up in the middle of the night to run it manually. So last night I scheduled it for just a one-time run at 3am. At about 5am I dialed in to check on it. It was stuck in the loop looking for "COMPLETE" and there was an "@" typed in after the word "Again?" I went into debug mode and stepped through the loop a few time. I backed out the "@" sign but the script kept putting it back in. I then patched the script and restarted it manually. It ran perfectly. What is going on here????? Shirley Hammack I.T. Financial Analyst Jackson County Memorial Hospital 580-482-4781 ext 2554 The documents accompanying this transmission contain confidential information, belonging to the sender, that is legally privileged. This information is intended only for the use of the individual or entity named above. The authorized recipient of this information is prohibited from disclosing this information after its stated need has been fulfilled. If you are not the intended recipient, you are hereby notified that any reading, disclosure, copying, distribution, or action taken in reliance on the contents of these documents is strictly prohibited. Violators may be prosecuted. If you have received this email in error, please notify the sender immediately and destroy the transmitted information.
