Thanks Thom. I'll see if I can get that to work. One more quick question....If I am using the New NUI connection (stMeditechNUIex) and I connect to an stWindows how do I reconnect, or activate the NUI connection? Connect "MeditechNUI" does not connect, but gives a "Cannot start Meditech" error. I assume because the command is looking to open a new MeditechNUI connection
Thanks. Brian Bennett Affinity Health Systems PBS\Clinic Billing (920)628-9055 [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Thom C. Blackwell Sent: Wednesday, January 09, 2008 9:29 AM To: [email protected] Subject: RE: [Talk] For|Next rule Greetings, Sounds to me what you want need to do is retain the value stored in T? Meaning you want to basically enter in, in the same place: T-1 T-2 T-3 Respectively? And check after each to see if an Error occurred? Attached is a sample project showing how I'd attack this. Of course this will require being grafted into your script = but hopefully it illustrates the point. Regards, Thom Thom C. Blackwell Product Manager Boston Software Systems (866) 653-5105 ex 807 www.bossoft.com Sign up for my weekly webinar! LEGAL NOTICE Unless expressly stated otherwise, this message is confidential and may be privileged. It is intended for the addressee(s) only. Access to this E-mail by anyone else is unauthorized. If you are not an addressee, any disclosure or copying of the contents of this E-mail or any action taken (or not taken) in reliance on it is unauthorized and may be unlawful. If you are not an addressee, please inform the sender immediately, then delete this message and empty from your trash. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bennett, Brian Sent: Wednesday, January 09, 2008 9:46 AM To: '[email protected]' Subject: [Talk] For|Next rule Can the following be done with a rule? For i=1 to 3 T = "T-" & i Next i If I direct the rule in a step to a sub routine that does the for|next the only answer I get is T-3, always skips over T-2 and T-1. I have the following: (the only way I could conceive a solution) If Rule("Print [EMAIL PROTECTED],1&@3,16") Then For i = 1 To 3 T = "T-" & i Stable 0.5 Enter T Stable 0.5 Enter T Stable 0.5 If At("[EMAIL PROTECTED],1") Then Step = "Stmnt Error" EDI_Transmit Else Step = "Download Statements" EDI_Transmit End If Next i Exit Sub End If If I F8 step through it it works fine. As soon as I go full speed it will enter the first range correctly, the second time through it will enter T-2 and then t-3 instead of t-2 and t-2. Any thoughts? I'm not finding anything that looks familiar in Talk archives. Thanks. Brian Bennett AHS Clinic Billing System Analyst 920-628-9015
