Hi, I'd like to point out that Roland Dreier's patch as detailed here: http://www.mail-archive.com/m...@openbsd.org/msg83528.html Works great on my little Soekris 5501 with a RT2661. (dmesg attached to end of this email.)
I do still get the odd wireless drop for 15-20 seconds, but it no longer brings up the OACTIVE flag on ral0 and it doesn't make the system completely freeze (no way of getting a dump, have to hard reset.) I emailed damien@ on December 1st and got no response. The author of the patch has expressed his frustration at being able to contact a developer to get this committed. I would be more than happy to do testing. Feel free to contact me.. I know it's hard to test all hardware devices when there is a lack of them. Regards, Tom (kernel was compiled by me, with aforementioned patch above, and is GENERIC) OpenBSD 4.6-current (GENERIC) #2: Fri Nov 27 12:20:04 GMT 2009 r...@pertho.net:/usr/src/sys/arch/i386/compile/GENERIC cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 500 MHz cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX real mem = 536440832 (511MB) avail mem = 511152128 (487MB) mainbus0 at root bios0 at mainbus0: AT/286+ BIOS, date 20/80/26, BIOS32 rev. 0 @ 0xfac40 pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000 pcibios0: pcibios_get_intr_routing - function not supported pcibios0: PCI IRQ Routing information unavailable. pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xc8000/0xa800 cpu0 at mainbus0: (uniprocessor) amdmsr0 at mainbus0 pci0 at mainbus0 bus 0: configuration mode 1 (bios) io address conflict 0x6100/0x100 io address conflict 0x6200/0x200 pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33 glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES vr0 at pci0 dev 6 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address 00:00:24:cb:a6:64 ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr1 at pci0 dev 7 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 5, address 00:00:24:cb:a6:65 ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr2 at pci0 dev 8 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 9, address 00:00:24:cb:a6:66 ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr3 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12, address 00:00:24:cb:a6:67 ukphy3 at vr3 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 ral0 at pci0 dev 14 function 0 "Ralink RT2661" rev 0x00: irq 10, address 00:14:85:d5:39:bb ral0: MAC/BBP RT2661D, RF RT2529 (MIMO XR) glxpcib0 at pci0 dev 20 function 0 "AMD CS5536 ISA" rev 0x03: rev 0, 32-bit 3579545Hz timer, watchdog, gpio gpio0 at glxpcib0: 32 pins pciide0 at pci0 dev 20 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 1: <WDC WD1200BEVS-00VAT0> wd0: 16-sector PIO, LBA48, 114473MB, 234441648 sectors wd0(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 2 pciide0: channel 1 ignored (disabled) ohci0 at pci0 dev 21 function 0 "AMD CS5536 USB" rev 0x02: irq 15, version 1.0, legacy support ehci0 at pci0 dev 21 function 1 "AMD CS5536 USB" rev 0x02: irq 15 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1 isa0 at glxpcib0 isadma0 at isa0 com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo com0: console com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo pckbc0 at isa0 port 0x60/5 pcppi0 at isa0 port 0x61 midi0 at pcppi0: <PC speaker> spkr0 at pcppi0 nsclpcsio0 at isa0 port 0x2e/2: NSC PC87366 rev 9: GPIO VLM TMS gpio1 at nsclpcsio0: 29 pins npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 usb1 at ohci0: USB revision 1.0 uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1 biomask e1c7 netmask ffe7 ttymask ffff mtrr: K6-family MTRR support (2 registers) vscsi0 at root scsibus0 at vscsi0: 256 targets softraid0 at root root on wd0a swap on wd0b dump on wd0b