On Wed, Mar 16, 2022 at 04:11:41PM +0100, Stefan Sperling wrote:
> This patch adds initial 11ac support to the iwm(4) driver.
> It allows use of 80 MHz channels and VHT MCS.
> 
> In net80211 I added a new rate control module to support VHT rates, as
> a new file called ieee80211_ra_vht.c, derived from ieee80211_ra.c which
> we use in 11n mode. The task of this code is to determine the fastest
> VHT rate that is usable. (This was not needed to add 11ac support to
> iwx(4) because iwx(4) devices perform this task in firmware.)
> Retries at lower rates must be handled by the driver. iwm(4) does this via
> the "LQ" command which sends a table of Tx rates the firmware should use.
> 
> So far, I have tested this successfully on iwm(4) 8265.
> In my testing performance peaks at around 250Mbit/s.
> There is no device-specific code involved so I would expect this to
> work on all cards supported by the driver.
> 
> I will test a few more devices I have here soon, but I don't have
> access to all iwm(4) hardware variants at the moment. Testing on any
> iwm(4) device would be appreciated. Please be precise about which model
> of iwm(4) you are testing on when reporting results.
>

No issues on my iwm(4) 8265 either. Seeing around 250Mbit/s here as
well! Thanks for all the work on these devices.

James

Reply via email to