Jeff; Unplug P/J 19503 on the convergence board to eliminate it or not. If the set comes on with P/J 19503 disconnected, the problem is on the convergence board. I had one of those drive me batty. Turned out that pin 20 of U19501 was pulled low. Problem was the glue under C19503 and/or C19581 had become conductive. But, at least unplugging P/J 19503 will cut the work in halve. Walter
--- Intrepid Video Support <[EMAIL PROTECTED]> wrote: > > Problem is set will shut down after it warms up. > When this happens, it tries to start again three > times, > then stays shut down. > It will repeat the three times sequence if I > press power. > HOT wave form looks fine, until it tries to > start, then it is bad. Kind of looks like one > wave form > super-imposed on another, trailing. Pulled HV > lead from splitter and symptoms are the same. > I disconnected the HOT collector and the set sill > not even try to come on. > This part stumps me. > Any ideas? > Thanks. > Jeff > -- > Intrepid Video TV/VCR Repair > 263 S Front St, Steelton PA 17113 > 717-939-7708; (F) 717-564-4952 > www.intrepid-video.com www.tech-repair.net > > > _______________________________________________ > Tech Repair CD...order your just $49.00 plus > shipping...One year of updates free. > www.intrepid-video.com www.tech-repair.net > Techs mailing list > [EMAIL PROTECTED] > http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com > ===== Walter Wood United TV Service 501 Poplar St. P.O. box 602 Pulaski Tn. 38478 mailto:[EMAIL PROTECTED] _______________________________________________ Tech Repair CD...order your just $49.00 plus shipping...One year of updates free. www.intrepid-video.com www.tech-repair.net Techs mailing list [EMAIL PROTECTED] http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com
