Your manual 2934 covers the 2804 series and the 2804 definitely contains fixes made in the 2704. Otherwise it would state that the 2804 requires this change.
If you use a manual that cover everything up to an including 2804, then you wouldn't know if any later fixes might have solve an issue you are working on. Short form: It is always better to use a recently later manual. Jack -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Didier Juges Sent: Saturday, December 23, 2006 8:52 AM To: !Time Nuts Subject: [time-nuts] Weird HP 5334B problem My HP 5334B has been doing the following since I got it off eBay this summer. It's not a major problem, but it is irritating and I would like to fix it, but I don't know where to start... At power up, when being fed two signals for TIC measurements, the instrument passes self test without error but is stupid: the trigger LEDs blink wildly without relation to the signals being fed, and the TIC measurement is stable but wrong (for instance, it would display 99 uS when fed two signals with 20 nS delay). As soon as I press the "READ LEVEL" button, the trigger LEDs start blinking in phase with the signal (assuming the trigger levels are set right, of course), and if I then press the TI button, it all works as it should. So I know now each time I power up the instrument, I press READ LEVELS once before doing anything else, and from there on, the instrument works as it should. It seems as if the trigger level DACs are not being initialized properly at power up, and pressing the READ LEVELS button fixes it. I did the READ LEVELS tests in the service manual and it passes. My counter is serial number 2804A01295, the service manual I have (from the HP web site) applies to instruments with prefix 2937A, even though it does list some changes that apply to early 2704A series. Particularly, there were some changes to the reset circuit with the early 2704A series, I do not know if these changes are in my instrument. Does anyone knows the differences between the 2937A series and the 2804A series? Anyone has a service manual for the 2804A series? Thanks for any help. Didier _______________________________________________ time-nuts mailing list time-nuts@febo.com https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts _______________________________________________ time-nuts mailing list time-nuts@febo.com https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts