At 12:38 PM -0800 12/26/06, Cornell wrote: >Looking for info, datasheet, or whatever.... > >Ovenaire-Audio-Carpenter (OAC) Model 84-14 10 Mhz oscillator, s/n 26816-2. >This is a 2" x 2" x 3.25" sealed unit which weighs 11.0 ounces. > >The top has two screws marked Freq Adj coarse and fine, and one brass >mounting pillar. > >The bottom has six solder pins and a coaxial output, probably for the 10 >Mhz, and two brass mounting pillars. > >The six solder pins, I assume, are for inner heater, outer heater, and >electronic frequency control, but I am not sure, just guessing. > >I got this device from the junk box at the Physics Department of the >University of Nevada, Reno. The engineers there did not know anything about >it, but one seemed to think it came from a piece of Fluke test equipment. I >read also on one of the time sites, that it might have been a substitute for >the 10811. All this is just supposition. > >Any info would be appreciated. > >Max Cornell KØMC >[EMAIL PROTECTED]
Max, Hi. I was just working on a Fluke 6082A synthesizer last week, and it has an oscillator oven that matches your description. I can look at the manual to see if it has any useful info. Otherwise I'd have to get the unit back from the radioastronomy grad students and open it up to see the connections. -- --David Forbes, Tucson, AZ http://www.cathodecorner.com/ _______________________________________________ time-nuts mailing list time-nuts@febo.com https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
