On the soekris board wiring the following instruction is given on the febo site http://www.febo.com/time-freq/ntp/soekris/index.html Run a wire from the junction of R61/R62 (near the backup battery) to one of the GPIO pins (I used PIO0, which is on JP3, pin 3) and from there to a TTL-compatible PPS signal such as the output of the FatPPS.
what is the purpose of this wire from r61/r62? on my board, a 4521 I can't find this junction with any degree of certanty, we we pulling the GPIO pin low here, or is something else going on? And another dumb freeBSD question where is the correct place to put the commands I want to run every time we boot basically I need to run sysctl machdep.elan_gpio_config=-----P...--..--------..--------- to set up the GPIO then I need to create a couple of symlinks in /dev for pps0 and gps0 we need to to this before the ntpd service is started or optionally start the ntpd service here after doing the above thanks for all the help .brendan _______________________________________________ time-nuts mailing list time-nuts@febo.com https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts