Can anyone give me advise with the following:
I have a Cesium Frequency Standard FTS 4050, that I powered up after it had
been stored for years.
It seams to work, but:
The beam current is way too high.
With monitor select on 3 (= beam current): the output on the meter is >5V.
The lock is on and the output frequency is 9 999 999.2 Hz.
The other readouts are:
Setting Reading
1 = QZ oven 3.5V
2 = CS Oven 1.2V
3 = Beam current >5V
4 = Control voltage 2.4V
5 = Supply voltage 2.8V
Any information on this would be appreciated.
Thanks,
Michel
____________________________________________________________________
DISCLAIMER - This message may contain privileged and confidential
information intended only for the use of the addressee named above.
If you are not the intended recipient of this message any use,
dissemination, distribution or reproduction of this message is prohibited.
If you have received this message in error, please notify the sender by
return email immediately and destroy the original copy. Any views
expressed in this message are those of the individual sender and may
not necessarily reflect the views of The Macservice Group.
_____________________________________________________________________
For more information on The Macservice Group, visit us online
at http://www.macservice.com.au
_______________________________________________
time-nuts mailing list
time-nuts@febo.com
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
