I have a few Trimble ACE-III receivers that I was going through setting their communications since I had a cobbled interface setup on my workbench.
I'm not sure how, but for some reason one of the cards was showing a lot higher SNR than the others... The receiver was showing SNR numbers in the 30's & 40's?!?! All the other receivers would show the satellites between 5-12 +/- I unplugged it a couple times (no battery) and it would show the same numbers always. I kept switching among receivers just to see what the SNR numbers were between each. Finally I did a complete erase/reset on the goofy one and that put things back to normal. I'm not sure what I could have changed, or even what those higher up numbers represented. There wasn't any other notation that changed, so I'm at a loss. Anyone have an idea, or should I just claim it was gremlins? Jason _______________________________________________ time-nuts mailing list time-nuts@febo.com https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
