In a message dated 19/07/2007 02:44:42 GMT Daylight Time, [EMAIL PROTECTED] writes:
My suggestion is that you pick up a free evaluation copy of Rick Hambly's TAC32 software at http://cnssys.com/cnsclock/Tac32Software.html . TAC32 knows all the quirks & options that ever existed in a Motorola receiver, going all the way back to the Rev.3 PVT6. Then if you find it useful, a legal copy can be purchased from Rick, or at members discount from TAPR (http://www.tapr.org/gps_tac32.html). ------------------- Hi Tom Many thanks for the suggestion. You may have seen my subsequent post in which I commented that I had tried TAC32 without solving my problem, only to find the kit was working ok but with an incorrectly labelled connector. TAC32 does look useful though so I'll check it over more thoroughly later. One "interesting" side effect...... Some time after shutting down TAC32 last night, but with the Oncore still connected to the serial port and outputting data, my PS2 connected mouse started misbehaving, with the pointer jumping all over the place then settling down for a while before repeating the performance. It didn't occur to me at first that the incoming serial data might have anything to do with it until it started again this morning and I eventually stopped it by disconnecting the serial lead from the receiver. Whilst I can't say for sure that running TAC32 was what caused it, it's not something I've ever seen in the past nor previously this past few days after running WinOncore. I'll check later to see if the port shut down properly and also take a look at the Oncore message stream, perhaps TAC32 may have changed something there as part of its auto setup routine? regards Nigel GM8PZR _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.