>>So far my conf file looks like: >> >>oncore 0 serial /dev/cuad1 >>oncore 0 pps device /dev/elan-mmcr >>oncore 0 pps flank assert >>ntpv4 0 listen * >>telnet port 123 >>telnet enable > >This looks good. > >Useful commands from the telnet prompt: > > "show oncore 0" > "show source" > "show source oncore_0" > "show source oncore_0 allan" >and > "show ntpv4 0 partner" >possibly > "show ntpv4 0 partner all" > >Poul-Henning
Thanks for the tips PHK! Right now the GPS is getting its almanac, it has been sitting unused for several months. I don't know if I will be able to get any useful information from it before I have to leave in 20min, but tomorrow should have plenty of time to tinker with it. One question, in the documentation I noticed there was a source that was an IP address (in a sample "show source" output). Can you list other NTP servers as sources? If so, what is the config line? _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.