Tom, Thanks for your reply. I looked through the documents on that page but unfortunately I don't think any quite address my question. I think they'd have to have a schematic of the board itself to do that.
If someone would just stick a multimeter probe on the 10 KHz connection of their module and then trace that signal back to the IC, I would really appreciate it. Thanks, David Carr On Thu, 20 Mar 2008 17:48:07 +0100, ScopeFreak <[EMAIL PROTECTED]> wrote: > David, > > On the site http://gpskit.nl/, in the downloads directory, you can > find a lot of info on the Rockwell Jupiter board. I know the info you > are looking for is in there somewhere. > > Best regards, > Tom > > On Thursday 20 March 2008 14:33, David Carr wrote: >> I have a Jupiter based receiver that is not one of the standard >> modules. I'd like to see if I can get a 10KHz output from it, but >> I don't know which pin of the 144 possible options to look at. >> >> Would someone with a Jupiter board trace the connection from the 10 >> KHz output back to the pin on the chip it originates from? That >> would be a huge help. I suspect that you'll find it ends up on the >> chip labeled 11577-11. >> >> Thanks for your time, >> David Carr >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow >> the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.