Peter Vince wrote: > Bruce, et al, > > The 1pps output of an HP Z3801A and Trimble Thunderbolt is > only available (as far as I know) as a balanced ECL signal on the > 25-pin connector, with dire warnings in the manuals about not > earthing either side of the ECL signals. Would you be able to advise > on a simple buffer circuit that would allow me to drive the usual > unbalanced 50-ohm coax please? > > Thanks, > > Peter Vince (London, England) > > Peter
The dire warnings about not connecting the outputs to ground indicate that the ECL logic is biased with Vcc ~ +5V(exact supply voltage depends on ECL family), Vee = GND. This is known as PECL (not pseudo ECL as some would have it, but positive (supply) ECL as opposed to NECL - negative (supply) ECL where Vee ~ -5V (exact supply voltage depends on ECL family). With NECL biasing shorting an ECL output to ground merely reverse biases the base emitter junction of the output npn follower, which won't destroy anything however no useful output will be produced. When Vcc is +5V then shorting the emitter follower output to ground produces a very high emitter current which may destroy the output device. Connecting a PECL output to ground via a 50 ohm coax termination will cause the output device emitter current to exceed its ratings. If the PECL outputs have suitable pulldown resistors then the differential output can be used to drive a twisted pair line terminated differentially (ungrounded resistor connected across the line) in its characteristic impedance. If the balanced transmission line is short (where the maximum length depends on the ECL output transition time) the termination may be omitted. The termination can also by omitted if the ECL outputs are back terminated with series resistors to match the balanced line impedance (provided that the line one way delay is less than 1/2 the minimum time between output signal transitions.). A differential input receiver can be used to translate the differential ECL signal to TTL/CMOS levels. Whilst one can use an RS422 or RS485 receiver, a PECL to ECL level translator will add less jitter since it doesnt have a built in resistive attenuator. Since several variants of PECL to TTL translators exist, one first has to determine if the outputs are conventional 5V PECL or reduced voltage PECL. This is easy to determine by measuring the PECL output signal levels using a high impedance scope probe, failing that even a high impedance DVM will work as the ECL output swing is 0.8V or less. Once you've determined the PECL supply voltage you can probably obtain PECL/TTL translators from Farnell (at least thats where Bilal Amin obtained his last year - SY100ELT23ZG for +5V PECL). The TTL/CMOS output should then be followed by a set of paralleled TTL input compatible (eg ACTXX ) CMOS inverters (in the same package with small resistors in series with each output to improve current sharing) to drive the 50 ohm load (just swap over the PECL (or other differential receiver) inputs if the output polarity is wrong. Alternatively if you prefer a quieter output stage, one could cascade a couple of long tailed pairs, one to drive the 50 ohm load and one to act as input level translator, however you will need a +12V 110mA supply for this. If an RS422 or RS485 differential signal has to be converted to TTL then using an RS422 or RS485 receiver is preferable as the RS422 or RS485 signal levels are not PECL compatible. It is also possible to use a fast differential comparator to do the level translation if nothing else is available. However some care is necessary particularly with single supply 5V comparators to ensure that the input common mode range isnt exceeded. Will post circuits shortly. Bruce _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.