Roy, I can't tell for sure from your comment if you need the manual for the 10811 but the manual for the 10811AB is available here: http://www.hparchive.com/
I think you might already know of this site but just in case. Joe -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Roy Phillips Sent: Wednesday, May 28, 2008 4:35 AM To: Time Nuts Subject: [time-nuts] The HP 10811-60111 Good members I have a 10811-60111 Crystal Osc. which is attached (15 way edge connector), to a PCB of Hewlett Packard manufacture. This later item has a type number 05328-20027 which suggests that it was part of the HP 5328 Counter. The PCB is about half as big again as the XTAL Osc., and has 4 IC's, 3 transistors, a "fine adjust" pot, and 2 adjustable C's (C12 & C15), and finally a 15 way identical edge connector. Rick pointed me to the Agilent "old equipment" site to download the 5328 Manual. This unfortunately does not have this unit within, but shows a simple smaller interface. It is obviously a complete control interface - ?oscillator and oven? . If anyone has the data on this unit I would be most grateful for a copy, in particular the edge connector, interconnections and set-up data. Roy Phillips _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
