Tom, Since everything is now UTC is it worth preserving this electric offset system ? It would certainly be a neater package if the TRF module actually fit within the case! My thoughts were to combine this with a 105B
On Mon, Sep 8, 2008 at 4:45 PM, Tom Van Baak <[EMAIL PROTECTED]> wrote: >> All, >> >> I purchased a 117A at a hamfest years ago and am just now looking into >> it. This 117A is a bit different from the ones in the manual and >> in pictures up on the web as it incorporates a telechron reduction >> motor installed in fthe area in front of the TRF module harness >> connector. Had not looked at this unit much as I did not have a >> manual which I now have as the power supply board (A9) had a charred >> hole blown in it. The TRF module does not insert fully into the >> chassis due to the presence of the clockwork module. Interestingly >> enough the clockwork looks like HP installed it or someone did a VERY >> good job. Does anyone know what this clockwork is intended for? > > Scott, > > I have a 117A like this too. The purpose of the motor and > its gears was to slowly move the phase in order to offset the > received frequency by some parts in 10^10th. This was done > in the 60's and early 70's to convert between UT (universal > time) and AT (atomic time). All part of leap second history. > > /tvb > http://www.LeapSecond.com > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
