Norman, PVC conduit sounds like a good solution.
I'm delighted to hear the frequency divider board is performing good service. I was rather surprised when there was insufficient interest to justify getting a further batch of boards made up. I'm pretty sure it would out-perform any micro based solution (no disrespect to the TAPR board intended) in terms of jitter etc. especially if you used thin film resistors instead of thick film in the clock circuit, but don't have the test equipment to measure that. I wonder if anyone did get round to measuring how good or bad it was - I did try (with a lot of help from Bruce) to design it to minimise that sort of problem. Dave -----Original Message----- From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf Of Norman J McSweyn Sent: 23 June 2009 11:54 To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] TNC connectors David, I used a piece of pvc conduit to mount the antenna. It fits in the vic-100's mounting skirt. If it does not have a mounting skirt, perhaps use a flange and drill the appropriate holes, apply RTV (or your favorite sealant!). Norm (The divider board is working like a charm!! Even impressed the heck out of my new GF!!! GEEEEKKKKKK!!!) David C. Partridge wrote: > Hi Dave, > > The Solartron 7081 is very happy and so am I :-). Thanks yet again > for all your help. > > Re: different sized centre pins - I know that's true of "N" type > connectors, > - you really don't want to push an N type male 50R into an N type female > 75R connector. However I'm pretty sure that it doesn't apply to BNC - just > wasn't sure about TNC. > > Dave > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.