On Mon, 13 Jul 2009 13:32:37 -0700, John Miles wrote: >What are you using for the Kvco constant with your 10811-based Thunderbolt? >If you don't back it down to -0.2 V/Hz, the loop's damping factor will be >very wrong, which might confuse the firmware. Check the Kvco, and also do a >factory reset after changing the OCXO to make sure it forgets anything it >might be remembering about the OEM part. (You might try that, too, Arnold.)
>-- john, KE5FX John, I put in as K0 what I measured several times with the 10811 as 'gain' with -0.74 Hz/V. Is that not the right way? I tried to use several times also higher values. The result was not impressiv, did not give clear signs either. A factory reset I did not perform yet, but I am trying at the moment the proposed 0.2 or even a bit lower values. Tomorrow I will check the result, but up to now I do not have a good feeling. What about all these recovery parameter settings? I believe that they are not really counting for this problem. Regards, Arnold _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.