If you go back to the page where I describe the GPS Monitor http://www.ko4bb.com/Timing/GPSMonitor/, you will see that the current chip is a 20 pin 8051 from Silabs, an C8051F330D or GP. Bob simply bought the chip I was using so that he could use my software. He changed the boot prompt and that's it. It is not rocket science. Everything is described on the page above, including the link to the Wiki page where the software and the compiler used are described in more detail.
One problem is that the C8051F330D/GP has become obsolete, so I will have to switch to another member of the family, probably a C8051F530A. The chip has a few more features, so that will allow a little more functionality. Unfortunately for hobbyists, the C8051F530A is only available in a TSSOP package, which is harder to solder by hand. The programming interface uses two wires and ground (and optionally Vdd). Didier KO4BB > -----Original Message----- > From: time-nuts-boun...@febo.com > [mailto:time-nuts-boun...@febo.com] On Behalf Of Bob Camp > Sent: Saturday, January 23, 2010 1:09 PM > To: Discussion of precise time and frequency measurement > Subject: Re: [time-nuts] ko4bb monitor > > Hi > > Looks like he simply swapped out the whole cpu board with one > of his own. Something using a 20 pin DIP package CPU with a 5 > wire programing interface from the look of it. > > Bob > > > On Jan 23, 2010, at 12:39 PM, Arthur Dent wrote: > > > Here is a photo of the fluke.l and Amazon Icruze display > boards if you're interested. > > > > > > > > > > http://farm5.static.flickr.com/4001/4297443401_eaedb898e9.jpg > > > > > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.