Hi Has anybody torn into one to see how easy/hard that would be? Sometimes HP's construction techniques are not very "hacker friendly"..
Since you probably will have multiple GPS's on the gizmo (why have it otherwise...) Leaving the 200 ohm DC resistors in place does not sound like a problem. Maybe you short out two of the DC blocks rather than just one. Bob -----Original Message----- From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf Of b...@lysator.liu.se Sent: Wednesday, January 27, 2010 9:41 AM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] HP 58516A GPS distribution amplifier information Hi, Another option is to remove the DC-block cap on port 1. Then let your primary GPS power the splitter and upstream antenna. http://www.to-way.com/tf/hp58516a.pdf -- Björn > Hi > > I found a SMC-BNC adapter of the correct orientation in the bottom of my > junk box. Somehow I doubt I'll ever use it for anything else. BNC cables > and jacks are something I can find easily. > > The top of the unit is held on with screws so getting inside it should not > be very hard. You could swap the SMC out to something that's more common > for power distribution. Maybe an APC-7 ... > > My guess is they used the SMC because it's unusual. That way you don't get > a cable with 30 VDC on it hooked where it shouldn't go. If you did run a > 30 volt supply the dc could do some damage. Of course 30 volts on that > unit connected to a "normal" antenna would do some damage as well. > > Bob > > > On Jan 27, 2010, at 1:14 AM, saidj...@aol.com wrote: > >> I recommend un-screwing that SMC since it is almost impossible to find >> the >> mate, and feeding two wires from a 5V supply into the unit through the >> hole, and soldering the wires to the PCB. Works well for me. >> >> bye, >> Said >> >> >> In a message dated 1/26/2010 18:36:18 Pacific Standard Time, >> bruce.griffi...@xtra.co.nz writes: >> >>> I'm using an HP 58516A GPS distribution amplifier to share my GPS >>> antenna between my receivers. >>> >>> What is the proper part number or connector "name" for the power >>> supply connector ? >>> >>> Thanks for your help ! >>> >>> Claude >>> >>> >> According to the datasheet option 05 uses an SMC connector for the >> power. >> >> Bruce >> >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.