"Bob Camp" <li...@cq.nu> wrote: > Hi > > Assuming it's an R1051 "standard" you then have to know who made it. Some of > the later parts made by the replacement parts empire were of questionable > performance / reliability. The side with the markings likely would tell us a > lot.
That was the side with the markings, such as it is. CAGE # comes back to 'Target Corporation', so aftermarket spares? And yes, it is certainly from/for an R1051. > > Simple answer - when it's not Chinese New Year, the auction sites are full > of < $20 OCXO's (including shipping) that will do a *lot* better. If you are > patient, you likely can get below $10. How they can do that with shipping is > a total mystery. I'm looking to cheaply upgrade an early non-oven Miller GPSDO. Looking at the schematic, there's no native way to pull this guy. I can wait for the CNY festivities to wind down. :) Thanks Bob & Arthur! -ls- _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.