Would you mind sending it direct to me at _ewkeh...@aol.com_ (mailto:ewkeh...@aol.com) as an attachment? You know we are in the test phase of a Dual Mixer and we are also running tests with the 10514 A and B along with the SYPD-1. The next board will accept the footprint of the 10514 B. Bert In a message dated 3/31/2010 9:37:55 A.M. Eastern Daylight Time, kilodelta4foxm...@gmail.com writes:
The manual is about a megabyte - the list will not accept it. ewkeh...@aol.com wrote: > Is there a way you can post it on time-nuts? > Thank you > Bert Kehren > > > In a message dated 3/30/2010 9:10:19 P.M. Eastern Daylight Time, > kilodelta4foxm...@gmail.com writes: > > We'll the "A"s are the package with the BNC connector. > > The "B"s are for OEM equipment, they had 6 pins and a smaller plastic > black case .... > > Turns out they have some of the lowest phase noise specs on record.... > > I can send the manual, if you like... > > Brian > > Mike Feher wrote: > >> I do not believe that I am familiar with the 10514B. I probably have >> > about 6 > >> or so 10514As with BNC connectors (most in a metal case and a few in >> > epoxy), > >> and, I recall from about 40 years ago a 10514A that was a small little >> > black > >> cube with leads for mounting on a PC board. Naturally, I had to take one >> apart back then as that was the fun part. In the late 60's I designed a >> thick-film phase detector that was used in an ASW system, where I simply >> matched the hot carrier HP diodes for a fixed voltage drop at a given >> current. We also wound the toroids, and had an op-amp on the output. Wow, >> that was ages ago. Regards - Mike >> >> Mike B. Feher, N4FS >> 89 Arnold Blvd. >> Howell, NJ, 07731 >> 732-886-5960 >> >> >> >> >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. >> >> >> > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.