Thanks Bill. I am heading right now to the Orlando Hamfest but will be on tomorrow. Bert In a message dated 2/11/2011 10:40:03 P.M. Eastern Standard Time, wb6...@cox.net writes:
Bert, The data sheet I sent you has a number of possible factory voltage options indicated where the specs show the operating voltage. Is there some specific marking on the one you have ? If so, then I would start out on the low side and slowly raise the voltage and evaluate the circumstances. A good picture would may help. Do you know where or what it came out of ? Bill....WB6BNQ ewkeh...@aol.com wrote: > Previously I asked about the Austron 1150 and got excellent information. > How ever all data sheets I received show 28 Volt power requirement. My > units have labels stating 12 to 28 Volt. Do these units have internal regulators > or what should I look out for. Thanks > Bert Kehren Miami > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.