Hi Remember that this started out running a sequence that was 127 hops long. With something that short, it's pretty likely you will be rude to somebody.
Even if you are running a massive hop rate, I can likely walk around and track you down within the average neighborhood. A diode detector behind a bandpass filter and a small-ish directional antenna is about all I'd try to use. I suspect it would also work with one of the power detector chips. Range wise, a lot would depend on just how good your local cable company is at keeping their stuff running right. I'm not really sure the chip would add a lot of range in a normal setting. Bob -----Original Message----- From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf Of jimlux Sent: Friday, February 25, 2011 10:57 AM To: time-nuts@febo.com Subject: Re: [time-nuts] PN sequence generation using GPS On 2/25/11 7:13 AM, scmcgr...@gmail.com wrote: > Speaking as a ham, if this is tried you will have hams complaining and DF'ing the offending signal. > Speaking as a ham, and as someone who used to build (and attempt to detect and jam) systems like this for a living.. The odds that a OO would see and recognize the signal is vanishingly small. As for DFing? It would be very difficult, considering that you need a wideband receiver to see the signal, and there are usually plenty of other signals in the band. Yes.. if I were radiating a few watts, and you were my next door neighbor, so my signal was really strong, and I used a slow hop rate, and you had a fast sweep spectrum analyzer.. you "might" be able to see it. IF you knew what to look for. More likely, you'd be talking about it to your friends and various mailing lists (like this one), and someone who knows someone who knows someone who is "interested" in such things would find out, and THEY would get out the fancy gear and they would track you down. That's what leads to the guy in the government car sitting outside your house one morning with "just a few questions". Basically, it all comes down to the "rude rule" - if you're rude to others, bad things happen. If you're fooling with a 10-20 hop/second hopper on, say, 2 meters, and you happen to put the local repeater input frequencies in your hop list, and you don't hop over the entire 4 MHz band, so you're hammering the repeater every few seconds.. and you run your link 24/7, yep.. you deserve the abuse you'll get. But for most people.. the hopper's interference would barely be noticeable. (4 MHz, 5 kHz channel spacing is 800 hop channels.. so at 10 hops/sec, you'd hit the same channel every 80 seconds.. And if you use a hop sequence that is longer than 800 (no reason not to...), it's not even like a repetitive interference. Maybe a weak signal guy running JT65 or something might notice something on their waterfall, but maybe not. > Chuck, you are correct in that no one but the hams care but the reason behind this is that policing the ham bands has been delegated to the hams and specifically certified 'Official Observers'. Once a infraction and especially a.unlicensed infraction is noted penalties are pretty severe and swift. > > If you want to do this get a 'experimental license' Well.. that *would* be a better solution, and the way to really go. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.