It's recommended to start your own thread, rather than hijack someone else's. Having totally irrelevant questions tacked on to an existing thread is very confusing and considered bad manners.
Joe Gray W5JG On Tue, Apr 12, 2011 at 10:37 AM, Paramithiotti, Luciano Paolo S <luciano.paramithio...@hp.com> wrote: > Hi all, > > Do someone have an interpolation board for HP5370A pn 05370-60119 to sell? > I have an Error 04 PLL not locked and vco range is out of range at +2.xx > Volts on one of the two boards. > > Thanks, > Luciano > > Luciano P. S. Paramithiotti > > > > -----Original Message----- > From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On > Behalf Of Joseph Gray > Sent: martedì 12 aprile 2011 17.37 > To: Discussion of precise time and frequency measurement > Subject: Re: [time-nuts] Ovenaire OCXOs > > After running overnight, the current draw has stabileized at 160 mA. I > tweaked the trim pot to set the frequency to 10,000,000.00 Hz, which is the > resolution of my counter. The counter is synced to the Z3801A. > The Ovenaire is exposed to ambient air, so I expect things to change as the > day warms up. > > Using an IR thermometer, the OCXO metal can temperature varies a bit, but has > a hot spot at 37.6 C. I'll have to dig out a contact temperature probe for > more accurate readings. > > Later on, I'll put this thing in an enclosure, which should minimize > temperature effects. Then I can see where the temperature stabilizes from the > oven heat. The T.I. comparison will have to wait a few days, as I need my > laptop for something else tomorrow night. > > Joe Gray > W5JG > > On Tue, Apr 12, 2011 at 7:27 AM, John Green <wpxs...@gmail.com> wrote: >> Interesting. I have several Ovenaire OCXOs of differing models. I used >> to think they were pretty stable until I compared them to my Z3801. >> Compared to a '3801, they stink. But then, a rubidium stinks compared >> to a 3801. Most have a voltage input for frequency adjustment but one >> has a trimmer cap for coarse and a pot for fine. Over a period of >> several days, I would think it had settled down only to come back and >> find it had suddenly shifted. As they say, stable is a relative term. >> About all I can say after testing maybe a half dozen from different >> manufacturers it that the specifications should be taken with a >> liberal dose of salt. I have seen TCXOs do better than a lot of OCXOs >> over the limited temperature range of my lab. I have a chamber and >> keep saying I am going to do some temperature testing but work is always >> getting in the way. >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
