Hello,
My new to me counter has a strange response when I change the input frequency.
With the gate set to 1s, I can measure 100 MHz with plenty of digits. Then I
change the frequency to 1 MHz and it takes several seconds to almost a minute
for the display to change from 100 MHz to 1 MHz. The delay only occurs when I
lower the input frequency quite a bit; 100 MHz to 10 MHz changes are displayed
within 2 gate times. When I increase the frequency form 1 MHz to 100 MHz I
always get the correct display after two gate times. This delay is proportional
to the gate time; the updating is 10 times faster with 0.1 s gate time.
Is this behavior typical for this counter?
Thank you
John Pease
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.