http://forums.ni.com/ On Sat, Nov 19, 2011 at 7:28 AM, Chuck Forsberg WA7KGX N2469R <c...@omen.com> wrote: > I found some working diagnostics in ate7.zip on their FTP site. > The following works in gpib.conf. Notice no _accel in the board type. > Apparently the "turbo" inscription on one of the ASICS is a bit fanciful. > DMA doesn't work but is not needed to read the counter. > > interface { > minor = 0 /* board index, minor = 0 uses /dev/gpib0 */ > board_type = "ni_nec_isa" > name = "at" > pad = 0 /* primary address of interface */ > sad = 0 /* secondary address of interface */ > timeout = T3s /* timeout for commands */ > > eos = 0x0a /* EOS Byte, 0xa is newline and 0xd is carriage return */ > set-reos = yes /* Terminate read if EOS */ > set-bin = no /* Compare EOS 8-bit */ > set-xeos = no /* Assert EOI whenever EOS byte is sent */ > set-eot = yes /* Assert EOI with last byte on writes */ > > /* settings for boards that lack plug-n-play capability */ > base = 0x2c0 /* Base io ADDRESS */ > irq = 7 /* Interrupt request level */ > dma = 0 /* DMA channel (zero disables) */ > > master = yes /* interface board is system controller */ > } > > > On 11/19/2011 07:05 AM, paul swed wrote: >> >> Is that an isa board as I recall? >> I seem to remember the 7210 chip from ages ago. >> Regards >> Paul. >> >> On Sat, Nov 19, 2011 at 9:48 AM, J. Forster<j...@quikus.com> wrote: >> >>> Call or email National support. They were very good, last seen. Try and >>> get the diagnostics. >>> >>> -John >>> >>> =========== >>> >>> >>>> I got a National Instruments AT-GPIB board that I can't >>>> make work. It has a NEC 7210 in the upper right hand >>>> corner of the board. It also has a National Instruments >>>> 700454-01 A "TURBO 488" chip in a socket. >>>> It has a ASSY180625-01 REV C2 a/n 3748. >>>> >>>> I can't find gpib.conf parameters to make it it work. >>>> >>>> The software does work with a PCIIa board. >>>> >>>> -- >>>> Chuck Forsberg WA7KGX N2469R c...@omen.com www.omen.com >>>> Developer of Industrial ZMODEM(Tm) for Embedded Applications >>>> Omen Technology Inc "The High Reliability Software" >>>> 10255 NW Old Cornelius Pass Portland OR 97231 503-614-0430 >>>> >>>> >>>> _______________________________________________ >>>> time-nuts mailing list -- time-nuts@febo.com >>>> To unsubscribe, go to >>>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>>> and follow the instructions there. >>>> >>>> >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > -- > Chuck Forsberg WA7KGX N2469R c...@omen.com www.omen.com > Developer of Industrial ZMODEM(Tm) for Embedded Applications > Omen Technology Inc "The High Reliability Software" > 10255 NW Old Cornelius Pass Portland OR 97231 503-614-0430 > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. >
_______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.