Thank you Bob! I just tried removing the "lock" indicator LED on my three 5680A units and sure enough, in every case, there was the 1 PPS (+5V, 1 usec, rise/fall time ~100 ns) just as if it had always been there.

As a reminder, this and much else useful lore is now collected at the ongoing FE-5680 FAQ at http://www.ko4bb.com/dokuwiki/doku.php?id=precision_timing:fe5680a_faq

(and if the answer to any of your nagging FE-5680A questions is missing from the FAQ, please feel free to add it!)

-John

On 2/2/2012 12:46 PM, bob grant wrote:
Some info...

Its tempting to attach an LED to the /LOCK signal on the DB9.
However this signal is very weak and the LED does not seem very bright
and PPS signal does not pulse...Hmm

Internally the /LOCK pin is connected the 74AC240 buffer, but with an
LED helping to keep the signal voltage high (2.3V) a logic low is never
asserted.
This logic low is needed to enable one half of the 74AC240 buffer (pin
1) that gates the PPS signal.

Don't directly drive LEDs from the LOCK signal on the DB9 and, voila,
the PPS signal reappears.

Bob


_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to