On 02/07/2012 08:12 PM, Hal Murray wrote:
li...@rtty.us said:
Thank goodness for that inertia. I can still cable up a 100Kcps sine wave
standard to run stuff from "long ago". When I run into a box that uses a T1
signal for a clock reference - not so easy in the basement.
How much gear is there that uses T1 for a clock input?
Is there any interest in a board/chip/whatever that converts 10 MHz to T1? A
clean design using a decimal DDS should fit into a small FPGA, maybe a CPLD.
1,544 MHz is a bit funny, 193*8 kHz. On the other hand, a 1250 sample
long sample-memory and then toss that through a DAC and the sine can
then be smoothed.
A 2,048 MHz (256*8 kHz) could do just the same.
If you need a squarewave, then a sine to square converter will produce a
fairly accurate transition time signal.
Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
