Said,
are you using the Opt. 311 (MS-DOS) software?
I don't know of any more recent versions.
To answer your initial question:
You can not change anything on the diagram _after_ the measurement, not
even the title.
The spec lines will be visible only when you have defined them prior to
starting the measurement.
Regards,
Adrian
saidj...@aol.com schrieb:
Hello team,
I am trying to get an HP 3048A system up and running, and I am having
problems with enabling spec limit lines on the graph.
I can enter the spec line data under the "manipulate results" then "spec
lines" menu, but the lines I entered are not visible. There are the standard
spec lines visible when I do the internal noise floor test, so I know this
should work.
Does anyone know how to enable these properly? The user manual doesn't talk
about this, and it is written for an older version of the software
anyway's.
Also, I have software version A 01.01 from 1994, does anyone have any more
recent software version?
Thanks in advance,
Said
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
