Hi If you want to isolate things, the answer is fairly simple. Get a water cooler system (like on a high end PC) and adapt the cooling block to a metal box that goes around the TBolt. Put the pump and fan a good ways away and run them on an isolated supply (as in independently regulated. I *assume* you are already running a 15 or 18 volt supply into linear regulators to power the +12 on the TBolt.
You could also do acceleration compensation on the OCXO.... Bob On Jul 13, 2012, at 7:55 AM, Azelio Boriani wrote: > Peltier cooler on top of the OCXO or on top of the TBolt? > > On Fri, Jul 13, 2012 at 9:54 AM, Chuck Forsberg WA7KGX N2469R > <c...@omen.com>wrote: > >> How about a thermostatically controlled Peltier cooler? >> >> >> -- >> Chuck Forsberg WA7KGX N2469R c...@omen.com www.omen.com >> Developer of Industrial ZMODEM(Tm) for Embedded Applications >> Omen Technology Inc "The High Reliability Software" >> 10255 NW Old Cornelius Pass Portland OR 97231 503-614-0430 >> >> >> >> >> ______________________________**_________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/** >> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> >> and follow the instructions there. >> > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.