The picture, if attached, did not come through. Probably it was stripped off by the mailing list software.
I did located what I believe you were speaking of. A small white donut placed in the circuit board which was an attachment point for the trimmer and a smaller fixed capacitor and the "blue" wire going to the crystal. Mine looked ok but maybe a bit dry compared to two other such fixtures on the middle board. So I touched it up with more solder on both sides. I also touched up the other end of the small fixed capacitor. I have the oscillator running and so far it seems happier. It warmed up faster, the trimmer adjustment seems more sure-footed. On 11/17/2012 12:02 AM, Neville Michie wrote: > I have found a pic of the dry joint, > this one was just a dry joint with resin insulating the connection, > the other never had any solder applied. > cheers, Neville Michie > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.