The old Watkins Johnson M9 series was the state of the art for stacked diode mixers. You can still get the M9E and M9H from MaCom Technology Solutions. The M9E is better, but only if you have the 1/2 watt! of LO drive needed. As you have done already, it is probably possible to homebrew something like these. There were a series of papers written by WJ people 20 years ago or so in Microwave Journal or maybe it was Microwaves and RF that explained all about these things. These should be required reading if you are going to homebrew. Try to match the diodes so you get low DC offset. Some mixers also use resistors and capacitors to assist the diodes; again read the WJ papers.
The horsepower race in phase detectors was somewhat rendered unnecessary by the cross correlation techniques developed 10 or 15 years ago. You can extend the effective noise floor by dozens of dB this way. Rick Karlquist N6RK On 11/23/2012 7:42 AM, Anders Time wrote:
I have been using an minicircuits mixer as a phase detector for measuring low frequency(5-10MHz) and it is usually good enough. But when I want to measure 100MHz the sensitivity of the mixer decreases a lot, so when I want to measure some really low noise 100MHz(Pascall -178dBc floor with 18dBm out) oscillators the sensitivity is not good enough. I read in an old article by Walls, Stein et al(Design considerations in state-of-the-art signal processing and phase noise measurement system) that one can use two diodes in series in the double balanced mixer to increase the sensitivity. I tried this with some standard 1n5711 Schottky and the sensitivity is now 1V/rad, but is there a easier way to do this? /Anders _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
_______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
