I'm curious, which way you went and which accuracy you achieved... :-)
Can you tell us?
Volker
Am 06.12.2012 19:10, schrieb Paul DeStefano:
On Tuesday, 4 December 2012, Tom Van Baak wrote:
We are using the SR620 to measure the interval between 1PPS signals from
two clocks. One is the Septentrio PolaRx4 GPS receiver and the other
is a
Rubidium clock.
Many Thanks,
Paul
1) If you are making frequency measurements, the warm-up of the
internal oscillator is the major factor limiting accuracy. ...
Plotting digits of precision as a function of warm-up time would make
a very educational graph you could tape to the top of your SR620.
2) If you are making time interval measurements and using an external
standard, the warm-up time will also affect the accuracy of your TI
measurements, but to a far lesser degree. Here are informal results
for TI (time interval) mode after a 5 minute power-down (see also
attached plots):
- if you need 1 ns accuracy, you can use the SR620 immediately after
power-up
- if you need 100 ps accuracy, wait 2+ minutes
- if you need 10 ps accuracy, wait 15+ minutes
- if you need 1 ps accuracy, you need a seriously stable lab
environment or a different counter.
Given that you plan to use the SR620 with high-end GPS gear I would
suggest you try this quick experiment for yourself to see what *your*
SR620 does, with *your* inputs, in *your* environment. Your numbers
will come out different than mine; but the methodology is the same.
Your procedures can then be based on measurement and confidence
instead of guesswork and folklore.
Tom & Co.,
Thank you! These plots are excellent and will be very helpful. You are
quite right; we should do the test ourselves. We will definitely do
that. Obviously, there is not need to worry, as we can characterize the
instrument behavior ourselves, which is probably necessary anyway if
we're going to publish these measurements with error values.
Many Thanks,
Paul
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
