Rick, Good job on this effort!
Is there any document of the differences between the m12 and SSR-6T behavior on the comm interface? Are all m12 commands implemented for example? Are things like UTC offset implemented? Thanks, Said Sent from my iPad On Dec 21, 2012, at 8:26 AM, "W2GPS" <w2...@cnssys.com> wrote: > Tom, > > Synergy already has a carrier board to put the SSR-6T receiver into a VP, UT, > UT+, etc. socket. All that is needed is firmware support for the old 8-channel > messages. I am planning to implement this capability for Synergy. It's just a > matter of time and priorities. Eventually Synergy will have the solution for > this problem. If you could gather a list of Time-Nuts people who would like > one > or more of these and send it to Art that could speed the process along. > > Rick > > -----Original Message----- > From: Tom Van Baak [mailto:t...@leapsecond.com] > Sent: Friday, December 21, 2012 11:15 AM > To: Discussion of precise time and frequency measurement > Subject: Re: [time-nuts] SSR-6t Connector > > Hi Paul, > > I'm pretty sure the hp Z3801A and 58503A/B (and perhaps other 1990's era) > GPSDO > use the Motorola Oncore VP receiver. It was, and still is, a famous GPS timing > receiver. Later, many GPSDO evolved to use the Motorola/iLotus M12 receiver. > > The new Synergy SST-6T is a clever combination h/w and s/w that turns a uBlox > 6T > & PIC into a PCB that is both h/w and s/w compatible with an M12. It's a > drop-in > replacement. But as such, it won't work in a device that is uses an old > Motorola > UT/GT/VP receiver. > > I suggested that they also come up with a board that is VP compatible, but you > realize the number of 15-year-old Oncore VP's in the field is probably not > that > high. It would make an excellent labor-of-love project to create a > VP-compatible > uBlox 6T board, but it's probably not something you can make a business case > for. > > /tvb > > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.