Hello to the group. There is no need for slaves. Quite a while ago there was a slave but it was simply the master faking out a slaves position by delay. That said yes indeed the systems settling in well to the RB ref and I will switch over to the 3801 sometime this afternoon. Fired up the Austron 2100s Regards Paul WB8TSL
On Fri, Feb 1, 2013 at 8:54 AM, Stan, W1LE <stanw...@verizon.net> wrote: > Still locked onto the Dana/Seneca Loran stations at 8:38 am local. > Comparison to GPS/DO is about the same. No new slaves detected. > > Stan, W1LE Cape Cod > > > > On 2/1/2013 12:30 AM, Stan, W1LE wrote: > >> Fired up the SRS FS700 and auto found the GRI 89700 microsecond stations >> in Dana Il (master) >> and Seneca NY, (slave) both with equal signal strength of 63 db. Other >> slaves were not to be found. >> Noise margin of 32 dB and Rx gain of 72dB. So the Rx is all locked up. >> Tomorrow I will have more data comparing the 10 MHz from the T'Bolt. >> Right now they are comparing to within 10EE10. >> >> Stan, W1LE Cape Cod >> >> >> >> On 1/31/2013 10:44 PM, Stan, W1LE wrote: >> >>> What GRI should we be listening for ? >>> >>> Stan, W1LE Cape Cod FN41sr >>> >>> >>> >>> On 1/31/2013 9:56 PM, paul swed wrote: >>> >>>> Rich indeed its on the air. Warming up the FS700 to see if it will lock. >>>> Have a pattern ram thats getting flakey and takes about 30 minutes to >>>> warm >>>> up along with the oven. >>>> >>>> >>>> >>> ______________________________**_________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to https://www.febo.com/cgi-bin/** >>> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> >>> and follow the instructions there. >>> >>> >> ______________________________**_________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/** >> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> >> and follow the instructions there. >> >> > ______________________________**_________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/** > mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.