OK Stan,

What stations are you receiving - not GRI numbers but locations!

Bill Riches
Cape May

-----Original Message-----
From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On
Behalf Of Stan, W1LE
Sent: Tuesday, February 05, 2013 12:52 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Locked onto LORAN 8970 GRI Monday AM

at 17:45Z, after 27 hours of continuous lock:
freq offset is now -2.1E-12 and has been as low as -7E-13, compared to
T'Bolt 10 MHz.
Master station is at 59 dB, slave is at 63 dB signal strength.

Stan,W1LE   Cape Cod


On 2/5/2013 12:12 PM, Bill Riches wrote:
> Hi Paul,
>
> I thought I was receiving Wildwood which is 3 miles or so away but 
> apparently not.  I nulled out the sig with my LFL1010 loop and get a 
> null about 30 degrees which is toward Boston but maybe it could be 
> Seneca after figuring antenna error and Mag variation.  Signal 
> strength with the loop max is -40 db and null is -60 dbm. I did a 
> conversion and comparison using my icom 7600 and HP3336 sig gen.  
> Measuring with the HP 3586 did not agree with the previous method - I
imagine the modulation screws up its reading.
> I will play around with the Perseus later and see what that reads.  So 
> - My question is - what stations are you copying?  I will continue to 
> see if Wildwood comes up again.  My contact with Wildwood has left the
room!
>
> 73,
>
> Bill, WA2DVU
> Cape May, NJU
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>

_______________________________________________
time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.


_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to