Hi I started out with the PIC16's as well, I did projects using a number of them, and moved to the PIC18's long ago. If you were starting out today - which family would you start with?
Bob On May 25, 2013, at 10:03 AM, Azelio Boriani <azelio.bori...@screen.it> wrote: > I started with just the PIC datasheet to learn about the hardware > architecture and the MPASM to write (in assembler) the first try at a > PIC16C84 (at that time the PIC16F84 was not yet available). There are > plenty of sites about PICs and relative projects. The Shera controller > is based on PICs. > > On Sat, May 25, 2013 at 3:46 PM, Jason Rabel > <ja...@extremeoverclocking.com> wrote: >> I've decided I finally want to tackle learning how to use a PIC chip for >> some smaller projects. Can someone recommend me a good (and >> cheap) PIC, and possible some literature (be it a book or website)? I have a >> fairly recent willem eprom programmer that I'm hoping I >> can use. >> >> I don't know what all the features PICs have, but for my first project I >> would like to have it connected to a serial port on one of >> my Soekris' where it can grab info (i.e. the current time, or NTP/GPS info) >> and output that on a little LED display. >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.